How To Install Pegboard On Sheetrock
How To: Make a Pegboard Wall Organizer
We independently select these products—if you buy from one of our links, we may earn a commission.
Project: Pegboard Wall Organizer
Time: An afternoon
Cost: $xxx.00 (more than or less)
Our DIY home organization project for the New year involved hanging a pegboard organizer in our tiny kitchen. Although we plant lots of how-tos for installing pegboard on the spider web, very few of them had detailed instructions and supply lists, so we thought it would be helpful to document our own experience in stride-by-stride form.
Tools and Resources:
• One 2×four-pes pegboard*
• Two four-foot 1×2 planks
• Forest screws and plastic drywall anchors
• Drill
• Level
• Tape measure
• Pencil
• Pigment (we used some leftover Behr 510B-5 Jamaican Sea in semigloss)
• Paint tray and roller
• Contrasted pegboard hooks
*We bought our supplies at Home Depot, where pegboard, wood, screws, and hooks added up to about $30, but y'all could also find similar supplies at most hardware stores. Many hardware stores will cut the pegboard and 1x2s to a custom size. It's a skillful idea to employ semigloss (or even high-gloss) paint for the stop, since information technology's easier to make clean and wipe down.
- With your tape measure, figure out where you want to position the pegboard on the wall.
- Employ a pencil and level to marker the vertical (long) edges of the pegboard on the wall.
- From the vertical marks on the wall, measure one inch in and mark the spots for your drywall anchors. We used 6 anchors total (3 for each 1×2 support).
- Using a level to make sure the anchors are correctly aligned, drill your drywall anchors into the wall.
- Using the level again to bank check that your edges are straight, line up the offset i×2 against the wall, so that its broad surface is flush against the wall.
- Drill your wood screws through the ane×ii and into the drywall anchors.
- As y'all go, it helps to concord your pegboard upwards against the 1x2s to make sure it'southward straight and the edges line upwardly.
- When y'all're finished, you'll have two 1x2s fastened to the wall, like train track rails.
- Hold your pegboard upward against the 1x2s and line it up and then that the edges are flush.
- Forth the edge of the pegboard, thread a short forest screw through 1 of the peg holes.
- Drill the screw through the peg hole and into the 1×ii.
- Echo this step using as many screws as you retrieve you demand to hang the pegboard on its supports. We used 6 screws.
- Cascade the paint into the tray and employ your roller to coat the pegboard.
- Employ the paint in fairly thin layers. Otherwise, the peg holes will become gunked up with paint.
- Allow the paint to dry, then repaint with a second glaze. Nosotros institute that two coats were plenty for proper coverage.
- Accommodate the hooks on your pegboard, hang your stuff, and you lot're all gear up!
Nosotros're actually happy with the results. In addition to organizing our pots and pans, the pegboard adds a shot of color to our otherwise plain apartment kitchen. We worried virtually the pegboard looking cluttered, but the fact that everything'southward contained in a compact area makes it feel very organized.
Source: https://www.apartmenttherapy.com/how-to-install-a-pegboard-105114
Posted by: whitttiver1990.blogspot.com
0 Response to "How To Install Pegboard On Sheetrock"
Post a Comment